Newbie Networking Questions - CNCzone.com-The Largest Machinist Community on the net!

dm855 · #1 11-09-2010, 02:17 PM

Hello Team!

I'd like to know if these sepcific Fanuc controllers are able to be hooked up to a network...

16MA
16MB
16MC
15MA

Any help would be greatly appreciated. Thank you for your time!

underthetire · #2 11-09-2010, 03:48 PM

Not without the data server, and I doubt the A controls at all. Data servers were $$$. We used them on the early pallet pool systems.

dm855 · #3 11-09-2010, 03:56 PM

Thanks for the response.

So are the "B" and "C" type controllers able to be retrofitted?

underthetire · #4 11-09-2010, 04:13 PM

Sure, but the data server installed was like 10K each.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Networking of CNC machines	Klaus	General CAM Discussion	12	06-22-2011 12:25 PM
need networking help cent 1	adam12000	Milltronics	0	01-07-2008 06:57 PM
Networking problems	nian_id	Haas Mills	3	07-09-2007 05:08 PM
Networking Help needed!!!!	sco999	Milltronics	9	04-20-2007 07:43 PM
Dnc Networking	brtlatjgt	Machine Problems, Solutions , Wireless DNC, serial port	4	08-25-2006 11:32 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)