Need Help!- velocity control unit.

[r.2.d.2]

HI.
CAN ANY BODY HELPME?
WE HAVE A CNC MACHINE, IT'S.

CNC LATHE.
MORISEIKI TL-5, WITH 6T FANUC CONTROL

I NEED TO GET THE MANUAL OF THE NEXT EQUIPMENT:

FUJITSU FANUC.
TYPE: A06B-6045.

IT'S A SERVOMOTOR OF THE CNC LATHE.
WHERE CAN I GET ITS MANUAL?

I WAS VISITED MANY WEBSITES BUT I DON'T FOUND IT.

TANKS FOR YOU HELP.

BEST REGARDS.

[Al_The_Man]

6T its most likely a DC Servo, (yellow cap)?
What is the problem? it a DC motor!
Al.

[r.2.d.2]

THIS IS A OLD CNC MACHINE, AND THE FANUC 6T IS ITS CONTROL.

THIS MACHINE HAS MANY PROBLEMS.
THE CONTROL DON'T STAR UP.
SPINDLE MOTOR DRIVE HAS A PROBLEM (PROBABLY STAR UP PROBLEM CONTROL).
THE SPINDLE MOTOR TO DRIVE CONNECTIONS ARE INCOMPLETE.

BUT THE SERVO DRIVES SEEM IN GOOD CONDITIONS.
I DIDN'T SAW WORK THAT MACHINE BUT I WAS CHECKED AND FOUND THAT.

I WISH TO ELIMINATE THAT OLD CONTROL AND USE AN SOFTWARE PC AND LINUX BASED (EMC2). BUT I THINK I CAN SOME USABLE INFORMATION IN THE SERVO DRIVE MANUAL FOR THE CONTROL INTERFACE, YOU KNOW..

[Abdullah]

Originally Posted by Al_The_Man 6T its most likely a DC Servo, (yellow cap)? What is the problem? it a DC motor! Al.

hi i had a machine hitachi seiki 4 NE-2 with fanuc system 6t i had a problem with spindle its rpm are too low a gave him a command to run 3000 rpms but it runs only 300 rpms. plz help me sirrrrrr