Machine parameter edit procedure for FANUC 6T System

[VENKATESH REDDY]

Dear all

I have Daewoo PUMA 10 lathe with fanuc 6T control. machine is working ok.
i want to change the parameters like softlimt for X and Z axis .

Please give me the procedure to edit the machine parameters .

I will be very greatfull to you.


Regards

Reddy

[Al_The_Man]

Set ENABLE switch on main PCB, Set to MDI select PAR page set parameter and push INPUT.
Al.

[VENKATESH REDDY]

Set ENABLE switch on main PCB, Set to MDI select PAR page set parameter and push INPUT.
Al.

Dear Al The Man

I tried with setting the parameter write enable switch and system is showing the alaram 100 and set the selector in MDI mode and try to change the valve, but the system is not accepting any value. I am unable to enter more than 4 letters , the system is not accepting any value.

I wanted to change the X - & Z- Limit value i.e parameter No 147

Plaese suggest me to proceed further

Regards

Reddy

[Al_The_Man]

This method has always worked for me?
I confirmed the sequence as per the manual.
Are you sure you are in the right parameter page? Not diagnostic or anything?
Al.

[VENKATESH REDDY]

This method has always worked for me?
I confirmed the sequence as per the manual.
Are you sure you are in the right parameter page? Not diagnostic or anything?
Al.

dear Al The Man

Thank you very much for your quick reply. I followed the same as you expalianed and i am in the PAR page only.
is any parameter number to be edited before editing other parameters ?
I tried By selecting all the modes one by one ,but i am not able to edit the parameters

Is there any other method ?
please suggest me

Regards

Reddy

[blakemachine]

Just for reference I believe you have to put a "P" then type the parameter then imput?