| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-06-2010, 01:09 PM
| |||
| |||
I bought a used cnc mill with a fanuc 11m control on it it was working fine until this morning , and now the z will not move limit switches not tripped , all lights on all boards are green , no errors  , the tool changer is non working , but i will check to see if it settled and is tripping a switch ... any ideas ? cody
__________________ www.wildhorsemfg.com machinist / gunsmith accumax with Fanuc 11M , Harding retrofit (working on)  |
|
#2
09-06-2010, 06:56 PM
| |||
| |||
| problem fixed tool changer settled and was off a limit switch but there was no errors ... was a strange problem cody
__________________ www.wildhorsemfg.com machinist / gunsmith accumax with Fanuc 11M , Harding retrofit (working on) |
|
#3
09-06-2010, 07:17 PM
| ||||
| ||||
| That error would have been the responsibility of the MTB to place a message in the control, they probably missed or overlooked that one. Al.
__________________ CNC, Mechatronics Integration and Machine Design. “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| VQC 15/40 4th axis with M2 control | jimiscnc | Mazak, Mitsubishi, Mazatrol | 5 | 10-29-2009 09:14 AM |
| Cs axis control | guhl | Fanuc | 5 | 05-14-2009 05:48 AM |
| CNC 5-axis VMC with Siemens 840 control | jolliesconcept | Test Forum | 10 | 11-08-2006 07:37 AM |
| Rotation control help on A axis | Art Ransom | DIY-CNC Router Table Machines | 27 | 09-23-2006 07:04 AM |
| How to control 8 axis? | lepton | TurboCNC | 2 | 08-19-2006 09:35 PM |
| | |
Linear Mode
