Need Help! back up fanuc 21i M - CNCzone.com-The Largest Machinist Community on the net!

alvalejo · #1 07-26-2010, 02:54 PM

I reestore the back up from the memory card but there is a message and i do not know how to make it works

the message is PROG-ERR

please help me...

stevo1 · #2 07-27-2010, 09:35 AM

Is this when trying to run a program or at power up? Is it a PS alarm or an alarm number along with the message?

Stevo

alvalejo · #3 07-27-2010, 12:34 PM

is when start up in red PROG-ERR

i foun this information

”PROG–ERR” –– The embedded macro program information is
abnormal.
It informs that the content of the embedded macro program information
and the embedded programs is not matched. When the embedded macro
program is edited (state of ”PROG–SAVE”) and the power supply is
turned off / on without storing FROM, this display is blink.
In this case, please reload the embedded macro programs from FROM
by <RELOAD> operation.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fanuc 6T Back-up	mjsparks	Fanuc	1	12-19-2008 03:21 PM
Back up 9000 range on Fanuc 0M-C	OC_	Fanuc	5	01-16-2008 02:32 PM
I'm back	tbenefi33	DIY-CNC Router Table Machines	0	12-02-2007 12:03 AM
Fanuc Parameter back-up	chuy	Fanuc	12	07-24-2007 12:49 PM
Lie Back And Think Of Oz	WallCrawler	CNCzone Club House	4	05-11-2004 10:30 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)