Fanuc OT program copy - CNCzone.com-The Largest Machinist Community on the net!

hmc710 · #1 07-22-2010, 01:37 PM

How do you copy a program in a Fanuc OT control? My soft keys do not have the Copy or Move function they show in the manual. I can change the program number with the Alter key but have not found a way to copy it.
Thanks,

CNCRim · #2 07-22-2010, 01:47 PM

It's optional.

hmc710 · #3 07-22-2010, 03:05 PM

So does that mean there is no copy function on my model? Looks like its time to get the RS232 going......

dcoupar · #4 07-22-2010, 04:25 PM

Yes. Extended Edit is an option which apparently isn't turned on on your control. RS232 might be the way to go.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to run a program under Fanuc 6TA	samiahmed	Fanuc	1	03-16-2010 06:22 AM
copy program on fanuc series O or OT	cuz1007	Fanuc	4	01-27-2010 12:57 PM
New program on Fanuc 6t?	pob198	Europe Club House	2	01-14-2010 03:31 AM
Need option bit for Fanuc 15M to to copy programs	Factory Guy	Fanuc	2	01-24-2007 02:03 AM
Copy Program Section?	donl517	Milltronics	5	10-30-2006 05:47 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)