FANUC om c help

[MBecker]

Does anyone know what parameter will allow me to use a G23? My machine has used that command in the past but today it gives me ps 10 alarm.

Similar Threads:

• Need Help!- Fanuc drill tap center equipped with Fanuc OM-C i/o card details
• pro engineer post processor fanuc 18i mb5 and fanuc 180i Ma
• can fanuc ac digital servo amplifiers be run by a controller other than fanuc?

[stevo1]

IIRC the stored stroke check is an option on this control that is probably not active. PM me a list of your 900 parameters and I will take a look at them.

Sounds like either a parameter was changed or your syntax is not correct. I would vote for #2 (syntax).

Stevo