Need Help! Yang15ml Fanuc OT manual zero return - CNCzone.com-The Largest Machinist Community on the net!

robertbair · #1 06-28-2010, 07:18 PM

Please help. I had a small crash today which triggered alarm and shut machine down. Now when i try to zero the machine with the manual return zero it over travels in x. Ive restarted the machine several times and still wants to over travel in x. Please help i need to finish this part run tomarrow.
Thanx

stevo1 · #2 06-29-2010, 09:19 AM

Power up the machine holding down the "P" and "Cancel" keys at the same time. this will disable your softlimits unitl you do a zero return. This should allow you to home the machine.

I ass u me that the crash was in X?? You could have slipped a bit on the ballscrew and a gridshift may need to be done.

Stevo

robertbair · #3 06-29-2010, 07:21 PM

Thanx Steveo
I had to manually put the machine at zero return,delete all parameters and reinstall them. Been up and running all day.
Thanx again.

stevo1 · #4 06-30-2010, 07:32 AM

That sounds a bit overboard but as long as it worked and you are up and running.

Stevo

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ZRN (zero return mode) in fanuc 0m	PRIOR666	Fanuc	6	11-12-2011 11:12 AM
Fanuc 0-m zero return problem	jlong58	Fanuc	7	07-22-2007 08:36 PM
Return to Home Fanuc 0M-A	cnc4tr	Fanuc	10	12-31-2006 03:07 AM
Fanuc 5T Zero Return Problem	Stu-Jitsu	Fanuc	3	10-27-2006 10:05 AM
Fanuc 18M Z return	pinguS	Fanuc	12	07-26-2006 09:43 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)