Problem Fanuc O-TT tool setting proceedure - CNCzone.com-The Largest Machinist Community on the net!

BryCAM · #1 06-04-2010, 04:04 PM

Hi there,

Does anyone have any information on the correct proceedure for setting tool geometries? I have tried setting the workshift, then taking a cut, measuring the diameter and then entering MX(measured figure) in the geometry offset for that tool, but when I call that tool up and send it to a diameter in MDI it is consistently about 100mm out.

any help much appreciated.
bry

mousongie · #2 10-09-2010, 10:47 AM

Hi my friend! Are you sure you did zero return the axes before starting with tool set up. Please let me know if the problem still persist.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
setting the tool data and the tool offsets	Michael82	Mazak, Mitsubishi, Mazatrol	6	01-23-2009 01:50 AM
Need Help!- fanuc series oi-mb Setting tool height?	esadaddy	Fanuc	2	01-08-2009 01:15 AM
Need Help!- Haas Tl-1 (toolroom lathe) new power up proceedure?	Lumenium	Haas Mills	6	09-28-2008 12:31 AM
Need Help!- proceedure upload heidenhain parameters	bbrreid	Bridgeport and Hardinge Mills	6	02-29-2008 06:42 PM
Renishaw tool setting	djbarren	General Metal Working Machines	8	11-14-2007 07:27 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)