Alarm 1008 D450 SET ERR.

[quasarix]

its on Fanuc 0-MD.

Machine had parameters deleted, after i restored parameters as best as i could i get this alarm.
I was trying to input some D499-520.. for tool magazine setup but cant enter them (it was possible before)

any help welcome, manual aswell

[vinod-makino]

Originally Posted by quasarix its on Fanuc 0-MD. Machine had parameters deleted, after i restored parameters as best as i could i get this alarm. I was trying to input some D499-520.. for tool magazine setup but cant enter them (it was possible before) any help welcome, manual aswell

Hi ,

Could you please let me know what make machine
any alarm occuring ?
only magazine operation cant run ?

thanks\
vinod

[quasarix]

Originally Posted by vinod-makino Hi , Could you please let me know what make machine any alarm occuring ? only magazine operation cant run ? thanks\ vinod

that alarm 1008 pops up after machine is turn on


like i said parameters were deleted and this is how far i gone in restoring.
machine starts ok i can even move axes etc until like 5 sec after that alarm shows..