Need Help! Fanuc 10T Help needed - CNCzone.com-The Largest Machinist Community on the net!

jasonladams · #1 04-20-2010, 01:33 AM

Hi,

We have a Fanuc 10T controlled Yam lathe, had some diffculties yesterday getting a program into the control, kept getting a buffer overflow alarm. After about and hour I realised it was the M00 in the program causing the problem. Once removed the program went in fine. Is there a parameter I can chnage to prevent this being a problem in the future?

Many Thanks in advance.

JimBoyce · #2 04-20-2010, 01:53 PM

Was it Moo (letters oo) instead of M00 (Zeros)?

jasonladams · #3 04-21-2010, 03:50 AM

Originally Posted by JimBoyce

Was it Moo (letters oo) instead of M00 (Zeros)?

No Jim, program was written on machine and came out fine just wouldn't go back in? The buffer overflow alarm says that the machine has recieved the end of transmission signal but the input has continued for more than 10 characters? Never experienced a machine that considers the M00 as an end of program / transmission before?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fanuc 0M manual needed	TC Machine	Fanuc	6	04-21-2011 12:17 PM
HELP NEEDED! FANUC 6M W/O G54	SINUMERIKO	CNC Machining Centers	2	10-27-2008 07:34 PM
FANUC 21i help needed	rickst	General CNC (Mill and Lathe) Control Software (NC)	2	09-27-2007 07:26 PM
Help needed Fanuc 11-MA	Green Button	General Metal Working Machines	1	10-19-2006 01:59 AM
Fanuc 10M help needed...	rrcnc	General Metal Working Machines	1	10-20-2004 06:33 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)