Need Help!- Part counter

[1234567]

What do i need to add to my program to get the parts counter running.I have a Fanuc21i-mb control.

[peaceandcalm]

i know nothing about these machines sry, but if i want to guess i would try adding M25 just before the M30 (end of program)

[Ashish B]

Part counter is automatically configured to increase by 1 after M30.

Ash

[viorel26]

What values has parameters 6700 and 6710 ?
if param. 6700 #0 =0 then M02 or M30 should go
if param. 6710 has a value other than 0 then put a M whit this value at the end of program

[sinha_nsit]

M02 and M30 would always increment the part count, unless 6700#0 is set to 1.
In such a case, the count would be incremented by the M-code, stored in parameter 6710. This number can be same as or different from 02 or 30, but not 0, 98 or 99.
Do not miss EOB symbol after M02/M30/..., otherwise count would not be incremented, possibly without any error message.
#3901 contains part count, as read/write variable.

[1234567]

ok got it m54 before m30 .thanks everybody