| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-21-2010, 12:05 AM
| |||
| |||
I have the following boards in my possession for the 18i control A20B-3300-0070 486DX2 CPU A17B-3300-0101 Axis Card A20B-3900-0042 4MB DRAM A20B-3900-0061 1MB SRAM A20B-3900-0052 512MB SRAM A20B-3900-0053 256K SRAM A20B-2100-0220 2 Slot Back Panel A20B-2002-0470 Operator Panel Connection A20B-8100-0620 ?? A90L-0001-0423/105 Fans (2 each) Is this an ok configuration? I'm thinkin about selling the 512 and 256k SRAMS if anyone would like them.. I am assuming that an A02B-0236-C327 or A02B-0236-C125 MDI keypad.. or is it the A02B-0281-C120? I am not sure of the right CRT too. I am thinking about using the A06B-6096-C208 units with the A06B-0856-B302 or B200 motors (alpha 12/6000 & 15kW) and also the A06B-6102 spindle drive A06B-6087 power supply.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Configuration of Fourth Axis Configuration(Rotation of 360 degree z Axis) | Banda | LinuxCNC (formerly EMC2) | 1 | 07-12-2010 07:45 AM |
| Configuration help please. | George | Stepper Motors and Drives | 13 | 02-25-2009 02:48 PM |
| Tormach configuration | RP Designs | Tormach PCNC | 4 | 10-07-2008 01:14 PM |
| Need Help!- Configuration??? | derekreuvekamp | LinuxCNC (formerly EMC2) | 4 | 03-31-2008 09:25 AM |
| Changing configuration | barbter | NCPlot G-Code editor / backplotter | 3 | 12-24-2007 09:09 AM |
| | |
Linear Mode
