fanuc robodrill

[gergelb]

How do i reset a 2005 message (disk spring life over) on a fanuc robodrill

[zavateandu]

hi

u have to go in the maintenance screen and u will find a lot of maintenance components like spindle ventilator,coolers etc.

u have to reset the counter ,u have the posibility to clear it and it will start to count again from 0

all the messages apear with almost 80 or 120 hours before the lifetime will end so u also can change the time for message to appear.

if u want to send a message on cnc within 5 hours before ends the time u can do it.

but be carefull some of them u have to inspect,check,clean or replace and after that u can reset the counters.

maybe helps

GOOD LUCK!