How to run a program under Fanuc 6TA - CNCzone.com-The Largest Machinist Community on the net!

samiahmed · #1 03-16-2010, 03:01 AM

Finally I loaded my program to fanuc memory ,But now appear a new problem that is after I load the program I set the mode selector key to Tape Memory to run the program but I found nothing !!
I hit the start button also nothing happen
I attched two pictures to my fanuc CRT first one when i set the mode selector to tap edit and the other to tape memory
sami

greenery_fr · #2 03-16-2010, 06:22 AM

Originally Posted by samiahmed

Finally I loaded my program to fanuc memory ,But now appear a new problem that is after I load the program I set the mode selector key to Tape Memory to run the program but I found nothing !!
I hit the start button also nothing happen
I attched two pictures to my fanuc CRT first one when i set the mode selector to tap edit and the other to tape memory
sami

You have to run program in memory mode

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- FANUC 31i load program	Bama	Fanuc	1	04-18-2010 03:22 AM
New program on Fanuc 6t?	pob198	Europe Club House	2	01-14-2010 03:31 AM
Need Help!- PROGRAM CHECK FANUC O-T	Daniel Boone	Fanuc	6	11-08-2009 10:28 PM
Need Help!- Can't run Type II program on Fanuc 21i-T	SlowRiderr	Fanuc	4	11-20-2008 06:49 AM
fanuc program comments	Rich 72	General CNC (Mill and Lathe) Control Software (NC)	3	09-04-2007 07:38 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)