| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
04-25-2005, 11:38 AM
| ||||
| ||||
| IIRC The FAPT conversational language that Fanuc developed for graphical programming, on older Fanuc's had to have a board installed, but I am not sure on the Oi, most of the options are in the control on Fanuc, they just need turning on. Fanuc should be able to tell you what way you have to go, But usually there is a different keyboard also, with a FAPT selection key on it Al
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming PLC on Fanuc 0M | MetLHead | Machine Problems, Solutions , Wireless DNC, serial port | 19 | 06-27-2011 07:47 PM |
| Fanuc 3M DNC operation | max_c | General Metal Working Machines | 3 | 07-04-2010 08:11 PM |
| Fanuc motor ??? | jevs | Servo Motors and Drives | 3 | 03-16-2005 05:47 PM |
| Fanuc 21-GA_416 Alarm-Axis Disconnect | lasermike | Machine Problems, Solutions , Wireless DNC, serial port | 0 | 03-10-2005 01:49 AM |
| FANUC coding compatability?? | m1911bldr | TurboCNC | 3 | 04-24-2004 06:10 PM |
| | |
Linear Mode
