Need Help!- [B]Program upload problem with fanuc 6T[/B]

[samiahmed]

Hi all,
I try to enter a short program under Edit mode and all things is ok .When I change the mode to Memory mode to run the program .I can not find it where I entered the right program no. without any alarm.
while when I entered not exist program no it give me alarm no.071 "the address to be search was no found".
Thanks
sami

[dcoupar]

To input a program by keys:

EDIT mode.
PRGRM
O0001 INSRT (creates program O0001)
Key in each block followed by INSRT.

To search for program:

EDIT or MEMORY mode.
PRGRM
O0001 and cursor down

To see a list of all programs in memory (Memory Arrangement):

EDIT mode.
PRGRM
CAN
ORIGIN

[samiahmed]

hi dcoupar,
How can I run a program in memory?
thanks

[dcoupar]

1. Select the program you want to run:

MEMORY mode
Key in O0001 or whatever O number you want to run
Press the cursor down key

2. Press CYCLE START

[samiahmed]

hi
I try to enter a short program under Edit mode and all things is ok .When I change the mode to Memory mode to run the program .I can not find it,
Does this sound a memory problem?

[dcoupar]

In EDIT mode, type O then press cursor down. Does the program on the screen change to the next program in memory? Keep doing this... it should change programs every time.

[samiahmed]

The problem is there is no programs in memory else one I entered before under edit mode?
also I note the BMU switch on master board was on then I change it to off state and I am not sure the purpose of this switch but I read before that change the state of this switch may cause damge to memory?
thanks

[dcoupar]

I've never seen the BMU switch you mentioned. It would seem that this would be short for Bubble Memory Unit, but I could be wrong. Why did you turn it off?

[samiahmed]

I turned it off because I read before in some froums:"DO NOT TOUCH the toggle switch on the main PCB marked "BUBBLE FREE MODE". It can damage your bubble memory board unless you really know what you're doing"
and I see in some pictures that standard position is in the off state .
if you have any idea please let me know!!
thanks