System Variables Fanuc 11m

[Molds0]

Does anyone know, off the top of thier head the system variables where the current X, Y, Z and B axis locations are recorded on the Fanuc 11? Currently we are programming a B axis rotation in each sub-program, because I dont have a way to check it's current position, it is just a lot of extra wear on the machine, and extra time that the machine is not making chips. FYI this is a rotary 1 degree table, not the full fourth axis.

Any help would be appreciated.

[Molds0]

bump

[Al_The_Man]

They start at variable #5001.
Do you have the programming manual?
Al.

[Molds0]

Al,

I do, but it is the Toyoda version of the manual, I have not been able to find those variables. I would love to find a full listing.

Thanks for your help...I am assuming they run:

5001 is X
5002 is Y
5003 is Z
5004 is B

[Molds0]

My last post wasnt entirely accurate, they do give a list of general catagories of system variables, but nothing specific enough to be useful

[chucker]

Fanuc%20Variables(1).xls

[Al_The_Man]

I have the 15m list which should be the same, if you send me a PM with an email address.
Al.

[Molds0]

Thank you Al.....life is good

It is amazing how much easier programming is when you have all the pertinent info