Help with radius with 8025 tg

[Captdave]

Hey guys,

I need a little help with programming a .050" radius at the end of the threaded dia to add a little strength. I've tried adding a G36 at the end of the .497 N120 move but no luck getting it to work. Most all my programming I do in Mazatrol and only use this machine for second operations. BTW, the area has already been roughed out on another machine process.

00095
N01 (1/2-20 MALE)
N02 (7/8 HEX 12L14)
N03 (1.0"THREAD)
N10 G90 G95 G97
N20 G5 S1500 T08.08 M3 M8 (ROUGH TURN)
N25 G53
N30 G0 X -.750
N40 Z -.800
N50 G1 Z -.999 F.003
N55 G0 Z -.700
N60 X -.555
N65 G1 Z -.999
N70 G0 Z -.005
N75 G1 X.025 F.005 S2500
N110 G39 R.065 X -.497 Z0
N120 X -.497 Z -1.00
N130 G36 R.105 X -1.00 Z -1.00
N140 X -1.00 Z -1.100
N150 G0 X -1.100
N160 Z1.0
N300 G90 G95 S1500 T06.06 M3 M8 (THREAD 1/2-20)
N310 G0 X -.505
N320 Z.200
N330 G86 P00 = K -.500 P01 = K.200 P02 = K -.500 P03 = K -.940 P04 = K -.0330 P05 = K.015 P06 = K.020 P07 = K0 P10 = K.050 P11 = K0 P12 = K59.5
N340 G0 Z1.50 M9
N350 M30