Fagor CNC controls

[cadcamsolutions]

Hi carlos , the matter is we dont have a copy of the old parameters. the control is a 800 MG and when the control starts error 064 is displyed due to the parmeter loss.
Any help ?

thanks.

[kcho]

First of all the error 64 must appear when you don´t have active the emergency input in the cnc. You mut check the 14th pin from I/O1 conector. Usually the emergency chain is connected there. Sometimes when your 24 power supply doesn´t work this error is active. Check this and tell me the results please.

Carlos Cabrera

[Mert-G]

Hello Cadcamsolutions,

As addition to Carlos' suggestions;

According to the code of your CNC you must have an external PLC (PLC64?) and that error may appear because;

1) PLC program is not compiled

2) There is a PLC-CNC communication problem (RS485-RS232)

3) Some PLC registers' bits are not set properly