Fagor 8055t lathe / Mastercam post

[MBFisher]

Can anyone out there help me out with either a copy of a mastercam post that is capable of canned drill cycles for a Fagor 8055T lathe controller or possibly help me out with modifying the one I have. I have managed to modify the post to do everything except output the "Drill Point" Z position. Does anyone know how to source this in a mastercam post.

Cheers

Mark

[steveo]

Setup your drill. In parameters select the drill point button, select point entry. If no point or line exists make one. Be careful with using abs and inc. steveo

[1081275]

Can anyone out there help me out with either a copy of a mastercam post that is capable of canned drill cycles for a Fagor 8055T lathe controller or possibly help me out with modifying the one I have. I have managed to modify the post to do everything except output the "Drill Point" Z position. Does anyone know how to source this in a mastercam post.

Cheers

Mark

You have the mastercam post processor for fagor 8055t can you help me?

Thanks

[bthomps5]

i need post for my 8055t lathe control
dealer sent me my post but it is all screwed up
we have sent emails back and forth and still nothing even looks simular

[firekoe]

have u had any luck with getting a post to work?? i just got a fagor 8055 and was woundering if you would be willing to send me a copy of the mastercam post?

Thanks