| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fagor Automation Discuss Fagor Automation products here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
06-10-2010, 03:56 PM
| |||
| |||
| Got the parameters reloaded without too much trouble, now getting alarm 064 emergency stop. The button on the operator is not depressed (twisted and released) and as far as I know that is the only external E stop on the machine. The manual says: external emergency input (pin 14 of connector I/IO) is activated. I didn't find any parameters that effect pin 14. Not a problem before the battery went dead. Any ideas or suggestions? Last edited by Captdave; 06-10-2010 at 07:26 PM.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fagor 8025T dripfeed problem | Jerry Shorter | Fagor Automation | 11 | 05-26-2011 03:52 AM |
| Reloading of Loss Parameters for QT-6T Mazak Lathe | flomatic | Mazak, Mitsubishi, Mazatrol | 2 | 08-02-2009 04:25 AM |
| Reloading of Loss Parameters for QT-6T Mazak Lathe | flomatic | Mazak, Mitsubishi, Mazatrol | 1 | 07-28-2009 10:30 AM |
| reloading the dgn parameters | CHANDRU | Fanuc | 0 | 06-18-2009 08:07 AM |
| Reloading Fanuc OT parameters | senna95 | Fanuc | 8 | 10-13-2006 05:38 AM |
| | |
Linear Mode
