We have been having no problems with the 8025MG until the other day. We were running a program steadily all day, and all of a sudden the program would hang up toward the end. Now today when I try to run the program in automatic mode, it only runs the line I start at. The screen displays the current line it is on and says IN EXECUTION, but will not move onto the next line. All programs I try do this, no matter the complexity.
Any one have any ideas?
We called Fagor support, and they had us check the dead band parameters(118 218 318) and somehow one of them was changed to 0, so we changed it to allow for play. I guess its time to tighten the machine up.
But the control and machine are running fine now