8025MG trouble in automatic mode - CNCzone.com-The Largest Machinist Community on the net!

bigred · #1 03-03-2010, 01:00 PM

We have been having no problems with the 8025MG until the other day. We were running a program steadily all day, and all of a sudden the program would hang up toward the end. Now today when I try to run the program in automatic mode, it only runs the line I start at. The screen displays the current line it is on and says IN EXECUTION, but will not move onto the next line. All programs I try do this, no matter the complexity.

Any one have any ideas?
-Anthony

bigred · #2 03-03-2010, 02:10 PM

Update:

We called Fagor support, and they had us check the dead band parameters(118 218 318) and somehow one of them was changed to 0, so we changed it to allow for play. I guess its time to tighten the machine up.

But the control and machine are running fine now

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
New Machine Build- spline mode nurbs mode	cooltool	CamSoft Products	4	03-10-2009 02:03 AM
lazycam image mode trouble	pistolknight	Engraving Machines	4	11-16-2008 08:47 AM
What is - Torque Mode? Position Mode? Speed/Velocity Mode?	sunmix	Servo Motors and Drives	25	10-26-2008 03:53 AM
Need Help!- Mazak QT15 with T32-B control does not switch to automatic mode	MarkusFunk	Mazak, Mitsubishi, Mazatrol	2	06-05-2008 09:54 PM
Automatic Toolpathing	camtd	Mastercam	2	05-28-2007 09:23 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)