PLC error : Maybe you have an overheated motor or a broken wire.
Carlos Cabrera
I am guessing this is a machine builder ( Lagun) error code.
I looked for resets in the control cabinet. Reset the breakers.
Looking for ideas of where to go next.
Similar Threads:
- Need Help!- 4020 won't go into Cold Start . "Error- Enter Again or Hit Manual to Exit"
- Smoothstepper "Ran out of Data" error- also - having to double hit start from zero.
- "limit switch triggered" aleatorio en Mach3, Ruido?
- Newbie- Roughing and finishing not working plus "limit switch triggered" in Mach 3
- Fagor error code " No Spindle Speed Value "
PLC error : Maybe you have an overheated motor or a broken wire.
Carlos Cabrera
Hi I'm not sure if it helps but I had a problem on my chic poncho lathe.8055. Turned out there was excessive ohms on the drive motor caused by a problem thermister in windings. The problem was sorted by placing a resister on affected pin out to drives to fool system alarm disappeared but now have no motor overtemp alarm. It's a price to pay for a working machine