Calmotion DNC

[masterfabr]

OK,got all my issues figured out and am confident of my operation of AlibreCAM. Problem is that the post only runs to about 1500 lines and stops. I know the toolpath is good as it runs 3 cut levels and then stops before the next cut level of the same toolpath. I'm guessing the Calmotion is not feeding more code into machine. Any ideas? Here's the area it happens at.


N1553X11.603Y-2.618Z-3.677
N1554X11.632Y-2.644Z-3.691
N1555X11.66Y-2.67Z-3.705
N1556X11.688Y-2.697Z-3.719
N1557X11.715Y-2.725Z-3.733
N1558X11.741Y-2.753Z-3.747
N1559Y-1.929F45.
N1560G2X10.808Y-2.118I-0.721J1.163
N1561G1X10.602Y-2.086
N1562X10.575Y-2.214
N1563X10.811Y-2.251
N1564G2X11.741Y-2.753I-0.246J-1.569
N1565G1X11.519Y-2.954
N1566G2X11.801Y-4.18I-0.954J-0.866
N1567G1X12.041Y-4.59
N1568Y-1.082


I don't read code too well yet. You guys see anything in it that would cause machine to stop?

[masterfabr]

Answer:
To post properly a alrge file using AlibreCAM and a calmotion device you need to set in post preferences in setup of AC to outpost list files or you will only get what the Fadal memory will hold.