| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fadal Discuss Fadal machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-17-2010, 04:03 AM
| |||
| |||
I'm looking at purchasing a (1994) VMC 15, but I need to remove the z axis servo motor and spindle motor wire loom, to fit it threw my garage door opening. Just wondering if there is anything that I need to watch out for when removing and then reinstalling? Will the z axis need to be retuned or tweaked after reinstall? Any help would be great Thanks  |
|
#2
01-18-2010, 10:44 AM
| ||||
| ||||
| CNCpilot-- Make the coupleron the Z motor before removing so that the cold start poistion will not be lost. As far as the Pendflex, just be gentle and careful so you do not damage the internal contents. Neal |
|
#4
01-19-2010, 07:58 AM
| ||||
| ||||
| Neal meant "mark the coupler". Also - dont forget to lower the spindle onto a block of wood. It will freefall once the motor is removed.
__________________ www.integratedmechanical.ca |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3 axis CNC Servo Controller with servo motors--$700 | CuttersCov | EBAY ADS | 0 | 07-23-2009 11:49 AM |
| Need Help!- Fanuc OMD 4th Axis Removal Problem | drgbt | Fanuc | 3 | 02-12-2009 01:34 PM |
| 2 servo in same axis | vortex | LinuxCNC (formerly EMC2) | 2 | 12-02-2008 07:06 AM |
| Newbie- 4th axis removal | fokusco | Haas Mills | 5 | 06-10-2008 05:53 PM |
| X3 z Axis Servo requirements? | replicapro | Benchtop Machines | 15 | 02-19-2006 11:36 AM |
| | |
Linear Mode
