| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fadal Discuss Fadal machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-22-2009, 12:18 PM
| |||
| |||
I am working with a used VMC 15 we just got and when I look in the manual from Fadal it shows a lube pump, however this machine only has grease zerks. Some on the -X end of the table and some up by the spindle motor. Is this all that needs lubed on this machine? One other question, when I cold start the mill after lining up the axis marks I get "Amplifier fault axis A" as far as I know I don't have an A axis. Do I need to go into the set programing and tell it there is only XYZ? Thanks for all the replies on my previous post. Mike  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mazatrol T1 Excess Z error and NHead Lube | c5chris99 | Mazak, Mitsubishi, Mazatrol | 12 | 12-03-2011 02:56 AM |
| Newbie- fadal vmc 15 spindle lube | timo2le | Fadal | 3 | 02-17-2009 02:44 PM |
| Auto Lube Setup Question | Chris64 | General Metal Working Machines | 0 | 01-17-2009 09:27 PM |
| Taig way Lube...Question | SpeedsCustom | Taig Mills & Lathes | 8 | 07-20-2008 08:32 PM |
| Alarm (low lube,pressure) question | BMackinnon | Haas Mills | 11 | 07-21-2007 05:45 AM |
| | |
Linear Mode
