VH 65 A axis rotation - CNCzone.com-The Largest Machinist Community on the net!

timo2le · #1 11-09-2009, 10:22 AM

I had posted previously on this.

The jumper socket is supposed to have 12-5 jumped along with another (I don't have a manual in front of me). I've been trying to get the 4th working (finally did) but I'm not sure about the jumper. I re-installed the 12-5. It had been cut somewhere in it's life, before me. The axis rotated +A CW, I clipped the jumper again. No change. I swapped the motor leads at the amp, (it didn't like that). What else can I do to change the direction of rotation?

Thanks,

Tim

denmar · #2 11-09-2009, 10:57 AM

TRY 7-10

DareBee · #3 11-09-2009, 11:16 AM

Is this how and where you have it mounted?

Neal · #4 11-09-2009, 04:44 PM

The jumper at J4 of pins 5 to 12 is for the direction of the motor along with the proper connection combination of the motor and tach wires.

Neal

timo2le · #5 11-11-2009, 11:16 AM

I do have the axis mounted as shown in the picture.

I did try swapping the motor leads (at the amp) so I will try swapping the tach leads.

Thanks,

Tim

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
B axis rotation formula.	fitzpatrick2362	General Metal Working Machines	2	11-20-2009 01:51 PM
B axis rotation	fitzpatrick2362	General Metalwork Discussion	0	10-12-2009 07:06 AM
Fanuc OM B axis rotation	Kev4966	Fanuc	5	10-16-2008 03:09 AM
X axis to A rotation	quemast	G-Code Programing	6	06-17-2006 09:36 PM
Converting X axis to A rotation	quemast	GibbsCAM	2	06-09-2006 11:17 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)