General Fadal Question

[Neal]

Denmar--
FYI-- the 1100-1 board is a power distribution board. The controller cards are the 1010 boards. The 1400-5C CPU can have up to 16 meg of expanded memory. The 1 gb memory is only available if you install the USB to RS-232 device and use a 1gb memory stick.

Neal

[FastFieros]

Originally Posted by coloradoskibum Is there a page/screen on the control that will show you the software and board revisions? Or does this show on a start-up screen when you power up the control? Jim

I see no one answered this one.

The version coming up is different on the SYS PROM models. The best to know what SYS is on the board is to check the CPU card 1400-? and you will see a smaller board attached. There will be a label on it with the SYS model.

On my SYS97.3 . you can go to the help screen ( MU ) from a command prompt and the SYS number is in the top left. However on SYS96 it does not do this.

[Neal]

Before the SYS style of software the software ID number is located on the bottom left of the last page of the Menu. On the SYS style of software the software version is located at the top of the screen on the last page of the menu.

Neal

[coloradoskibum]

Thanks again guys for answering my questions. I am going to try and look at a '97 4020 tomorrow and a couple Haas VF-3s.

Jim