Need Help! Memory Error XXXXXX - CNCzone.com-The Largest Machinist Community on the net!

teck · #1 09-02-2009, 11:34 AM

Hey guys I was wondering if someone can help me out earlier today we got this error when trying to upload a program into a Fadal VMC 4020 the error read MEMORY ERROR AT XXXXXXX. So we went ahead and ran some diagnostic test first the ram it passed. Then the Memory Expansion board and this is the result

SEGMENT 9 OFFSET=0001 WROTE=5A READ0A FAILED[PRESS MANUAL]

Do you guys think the memory expansion board needs to be replaced.

denmar · #2 09-03-2009, 10:33 AM

FIRST COPY YOUR BACKLASH TABLE AND THE PARAMETERS
RI the memory, if that dosen"t fix it, the type :
DI
G0 3000
AN FALLOW THE MENU

Neal · #3 09-03-2009, 11:06 AM

If you need to Zero the Memory follow the attached procedure.

Neal

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
unrecoverable memory error	Michael82	Fadal	4	10-14-2009 02:46 PM
Need Help!- out of memory error	encarlisle	UG NX	1	08-10-2009 09:05 PM
Need Help!- Out of memory error	zachf	BobCad-Cam	4	07-31-2008 09:22 AM
Memory Parameter Error?	John3	Fanuc	6	09-07-2007 10:17 AM
EMC memory error	tomekbrzozowski	LinuxCNC (formerly EMC2)	1	07-03-2006 04:04 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)