ATC Problem Z- dont go up 3.8" just 35mm - CNCzone.com-The Largest Machinist Community on the net!

Tomeeii · #1 09-02-2009, 09:10 AM

Dear Boss,

I have next problem: when i try change the tools the procedure is start well, but when the Z axis must be go up 3.8inch the machine is go to emergency mode.
The z axis all time go up just 34-35mm and tools half in the spindle and half is in atc. The machine was resetted total (battery removed from cpu card)
in setp menu i adjusted evrything . (i hope).
air we have enough,
Have u idea what was wrong?
MAchine is fadal 3016l with cnc88 hs.
The z servo was removed too .

ThanksTomee

denmar · #2 09-02-2009, 10:43 AM

check switch inside tool in out assambly

Tomeeii · #3 09-02-2009, 11:50 AM

i find the problem, it was one wrong settings in setp menu.
Now its works fine.

Thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Powermax 1000 intermittent "no start" problem	MoparJon	CNC Plasma and Waterjet Machines	14	12-17-2008 03:59 PM
Need Help!- Where to buy 35mm Shafts?	LinearMotionFan	Want To Buy...Need help!	0	12-12-2008 12:34 AM
35mm rods (60" long) for X-axis gantry support	LinearMotionFan	Linear and Rotary Motion	0	11-24-2008 04:36 PM
I have a big problem with "heidenhain Gcode".please help me!!!	ngocthiem3g	CNCzone Club House	1	09-16-2008 12:49 PM
40W "stamp maker" laser engraver problem	frgt1000	Laser Engraving & Cutting Machines	5	03-05-2007 03:45 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)