check switch inside tool in out assambly
Dear Boss,
I have next problem: when i try change the tools the procedure is start well, but when the Z axis must be go up 3.8inch the machine is go to emergency mode.
The z axis all time go up just 34-35mm and tools half in the spindle and half is in atc. The machine was resetted total (battery removed from cpu card)
in setp menu i adjusted evrything . (i hope).
air we have enough,
Have u idea what was wrong?
MAchine is fadal 3016l with cnc88 hs.
The z servo was removed too .
ThanksTomee
Similar Threads:
check switch inside tool in out assambly
i find the problem, it was one wrong settings in setp menu.
Now its works fine.
Thanks
Last edited by Tomeeii; 09-03-2009 at 06:17 AM.
Hello Tomeeii
I have the same problem, can you tell me what was your solution?
Thank you
Greetings.