factory warm-up program for fadal 4020

[wdwrd68]

Hello i was wondering if anyone had a copy of the fadal warm-up program.
The original program was deleted by accident. I would really appreciate it
if someone can post one or email me a copy thanks Jeff

[fizzissist]

Here's one I have for my 4020...

Don't know if it's factory or if I wrote it years ago.... Pretty sure it's mine 'cause of the N15.1 line number.

Haven't run it in forever, since I'll usually just run the program at 50% rapid till everything is consistent. Doesn't run the full table or full +/-Z, but that's because there's always different parts/fixtures on the pasture, and I can't afford to be running into stuff.

%
N1O2(WARMUP
N2L100
N3G0X15.Y8.Z3.
N4X-15.Y-8.Z14.
N5Y8.Z3.
N6X15.Y-8.Z14.
N7Y8.Z3.
N8X-15.Z14.
N9Y-8.Z3.
N10X0Y0Z14.
N11M17
N12M30
N13G0G90G40G80M5M9
N14T5M6
N15S1500M3
N15.1G0X0Y0E0
N16H5D5Z14.M8
N17L110
N18Z0H0M9
N19G0X0Y0E0
N21M2
%

[SBC Cycle]

The service programs are embedded in the memory. I can't recall how to retrieve them but they're there.

[Neal]

The service programs can be retrieved by entering "TA,2". There never was a "warm up" program written by the factory. We recommend that you write one that simulates the cutting feeds and speeds of the job you are runing.

Neal

[denmar]

use de WORKOUT 4020 program in TA,2 (no tools in the spindle)

[wdwrd68]

Thank You for all the help. I used the program Fizzissist posted and modified a few numbers and i am up and running. Thanks again Jeff