VMC 15 XT fit in garage?

[Hellpit]

So I've got a VMC 15 XT being delivered. But I've just now thought about the hieght of my ceiling and garage door header.

My Ceiling is 8', 6"
Header is 7'

Can I take this apart to sneak it in? Is it going to fit under 8'6"? Anyone got one to measure up?

How would you guys suggest moving these things around a garage?

[carbidecraters]

Yes Z axis motor comes off with 4 allen heads so you can easily slide it in. Make sure you mark your Z axis motor so you install it right or you may not get the right CS position. Slide it in and make sure you can get that Z axis motos on as some people have popped a small 5" hole in their ceilings...easily ran that way for sure!!

[Dyad1]

Not sure on that machine but you may also have to unbolt the flexible wireway at both ends and carefully lay it over to clear. These items are with the head all the way down as well. Had to do this with a 4020 and a 3016.

[Neal]

Hellpit--
Here is the data for the VMC 15XT attached.

[Hellpit]

Thanks for the help guys.

With the head/motor removed, does anyone know the height from base to the top of the cabinets?

[Neal]

Hellpit: try these dims out for size.

Neal

[Hellpit]

Originally Posted by Neal Hellpit: try these dims out for size. Neal

Thanks Neal, exactly what I was looking for. I shouldn't have an issue getting her in with the motor removed.

I think I'm going to get a bunch of 1/2" round bar cut to roll it around into place.