Air cooling is possible?

[hartan]

How to FADAL machine VMC 4020 activates air cooling of tool?

[denmar]

Air valve connected

[little bubba]

120V air valve, plugged into the M7 plug, a $2 valve to regulate pressure(a water valve), a few dollars in tubing, a few loc-lines, about $30 and done.

[lightningcool]

Are you asking about how to hook up through spindle air?

[hartan]

Originally Posted by lightningcool Are you asking about how to hook up through spindle air?

I wonder after cooling the tool. Cooling of the emulsion (M7, M8) I would like to replace the coll air.

[hartan]

Originally Posted by little bubba 120V air valve, plugged into the M7 plug, a $2 valve to regulate pressure(a water valve), a few dollars in tubing, a few loc-lines, about $30 and done.

So it is necessary to slightly modify the cooling system?

[cadman]

Originally Posted by hartan So it is necessary to slightly modify the cooling system?

I basically did the same thing. I mounted the solenoid/regulator assembly on top of the enclosure near the doors and ran an air line from the regulator to the coolant tube by the spindle. I installed a brass valve rated for air between the air line and coolant tube and turned it closed when running coolant so coolant couldn't make its way up to the regulator.

[denmar]

///