Y axis resolver/over temp faults

[smittys800]

Been awhile, been busy makin parts...until today.
Machine is a 95 VMC 15
Y axis was acting a bit weird, thought the heat was getting to it, so opened the cabinet to get some air to the boards. Never even had a chance to make any chips, as I would get a Y axis resolver fault/over temp fault. RE-set a few times, never would take.
So I thought I would have a look see at the Y axis, and the motor is blistering hot, cannot holod my hand on the case for more than a few seconds.
So are my fears that the motor is shot going to come true, or is their an somewhat easy fix?
Thanks,
Smitty

[smittys800]

So called my local FADAL pro, come to find out, when I set my HOME position, I set it at the limit of the Y axis, so when it is just sitting there, the servo is actually still pushing at the home spot, hence the insane heat.
So, put it all back together, re-set the home position for the Y, backed it off a couple hun, and runs like a champ.
Hope this helps someone else,
Take care,
Smitty