ESPRIT CAM

[Mopec]

Anyone running Esprit Cam on a Fadal Mill (6030)?
Looking for a Esprit cam post that works.

Thanks in advance.

[scadvice]

If you can print out the post commands of the Fadal program generator maybe we can fix it. I've done a few on other CAM systems and some are quite easy, some are not.
Steve

[Mopec]

Originally Posted by scadvice If you can print out the post commands of the Fadal program generator maybe we can fix it. I've done a few on other CAM systems and some are quite easy, some are not. Steve

I got most of the post writing code correctly. But having a problem with fixture offset. Really what I'm doing is a repostioning of the same part to get into a working area (long tube). It takes my G54 offset to start the program but when I reposition (fixture offset 2) it never goes to the right starting point. I know it is just my understanding of how it works. I keep reading the book but i just don't get it.

Also is there a tube drilling fuction so I can rapid down to the next surface after i drill the top surface?