| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fadal Discuss Fadal machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-17-2005, 05:15 PM
| |||
| |||
| 85 vmc 40 problems I just got my machine wired and hooked to my compressor. I started it up it asked what pulley setting I was @. I responded 3. I hit jog and got an amplifier fault, I hit jog again with alarm sounding and moved the axis into the alignment positions, hit emergency stop to reset the alarms and hit CS command for cold start and got a Z axis amplifier fualt. it seems it wont read the Z axis location. any way I cant home it to run a program. The servos manually move, the turret turns CW and CCW the spindle is taking the tool but I cant get it to really boot up. any suggestions for checking for a bad amplifier card?    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4020 4th axis problems | little bubba | Fadal | 3 | 06-13-2005 10:08 PM |
| Bp Series 1 Cnc - Z Axis Problems | MDA40 | Bridgeport and Hardinge Mills | 15 | 02-12-2005 10:38 AM |
| mystifying 320 problems | senor J. | Gecko Drives | 6 | 01-19-2005 08:40 PM |
| problems with tuning of Rutex drives | FrankdB | Servo Drives | 2 | 06-21-2004 04:16 AM |
| Accuracy problems | i228208 | General CAM Discussion | 26 | 05-30-2004 02:31 PM |
| | |
Linear Mode
