Fadal CNC Mill EMULATOR.EXE help w/MS-DOS

[StevenD]

Hello all,
A friend with a Fadal CNC mill passed along the MS-DOS based version of the emulator to me to try to get it running for him. I contacted Fadal and they suggested all the experts were here.

I suspect this MS-DOS EMULATOR.EXE program was written or last updated in 1996 based on the date of the zip file.

On a Win95 PC if I boot to MS-DOS and try to run EMULATOR.EXE the machine just appears to hang. If I add the memory manager EMM386 to the dos CONFIG.SYS file and try the same EMULATOR.EXE I then get an error with the memory manager.

Does anyone know the correct CONFIG.SYS entries and also AUTOEXEC.BAT entries (if any) to run this emulator program?

Are there any command line switches that need to be used with EMULATOR.EXE?

Thanks in adavance for any and all help.

Steve

[Neal]

Steven--
you may have a bad file. Call the Fadal programming dept at 818 727-2100 OPTION #3 and they will send to a clean copy.
Neal

[StevenD]

Neal,
Thanks. I have e-mailed support@fadal.com and am awaiting a reply. I waited on hold for awhile and thought I'd try it via e-mail. I do believe you're correct, upon further examination the .EXE file appears to have been written over with the mill instructions by someone. Again, thanks for the assist. Steve