Newbie- Anyone Around Orangeville On. Can.

[New Fadal Owner]

I just Bought A used cnc fadal 1991 at an auction. And i not to sure on how to run it and send programs out to it. It is all powered up and runs. If anyone can give me a hand figuring out some basic things That would be great. Thanks

[shelburnebri]

Hey just found a link it will tell you the pin config

http://www.connectcnc-dnc.com/Settings/Fadal%2088.html


Bri

[scadvice]

...http://www.fadalcnc.com/fadal_Tech_Docs1.htm This will give you the run manuals and just about every manual you need for a Fadal for free. You didn't say which control you have. I think it is a CNC88, but it could be a a CNC88HS. What machine series is it?
If you need more help just ask! Look over all the Thread postings on Fadals here. There is a lot of info to read up on!

Steve

[DareBee]

My service Tech comes out of Orillia.
Call Jamie @ 705-641-9797