Pitch error comp parameters? - CNCzone.com-The Largest Machinist Community on the net!

smooooooth · #1 02-05-2009, 04:00 PM

Any one know how toget into the pitch error parameters on a VMC 40 with a CNC 88HS control?

Neal · #2 02-05-2009, 05:28 PM

Use the "SV" command to access the ballscrew survey. If you need to procedure for the older machines call me at the office 818 727-2100 option #4 and I can fax it to you.

Neal

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FANUC OM/OT, pitch error compensation	sab	Open Source Controller Boards	1	06-21-2011 07:50 AM
Pitch Error Compensation	crow36	General CNC (Mill and Lathe) Control Software (NC)	3	06-21-2011 06:23 AM
Pitch error compensation parameters not displayed	sab	Calibration & Measurement	1	07-10-2007 01:10 PM
FANUC 21iT pitch error parameters missing	sab	Fanuc	4	03-10-2006 12:37 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)