does fadal support polar mode? - CNCzone.com-The Largest Machinist Community on the net!

brockmo · #1 12-03-2008, 12:20 AM

after reading through the manual it appears that fadal doesn't have any provision for polar coordinates.

Thanks!!!

CNCRim · #2 12-03-2008, 12:28 AM

lathe or mill? and what you want to do with it?

Neal · #3 12-03-2008, 02:06 PM

Polar coordinates do not work on any Fadal Control.

Neal

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
New Machine Build- spline mode nurbs mode	cooltool	CamSoft Products	4	03-10-2009 02:03 AM
Polar coordinate programing without polar coordinate interpolation.	TimD	Fanuc	0	11-10-2008 07:35 PM
What is - Torque Mode? Position Mode? Speed/Velocity Mode?	sunmix	Servo Motors and Drives	25	10-26-2008 03:53 AM
Uni-Polar or Bi-Polar, or does it matter?	imagineer	Stepper Motors and Drives	1	12-05-2006 10:53 AM
Electronic Utopia Bi-Polar Board (or other Bi-Polar boards)	ranman	Stepper Motors and Drives	51	05-29-2005 08:25 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)