| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fadal Discuss Fadal machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-20-2008, 07:27 PM
| |||
| |||
Anybody done this before? The X axis appears to be whipped. We had some plugged lube lines and it appears the linear guides are shot....lots of noise and the table jumps under medium cuts. The ballscrew seems fine with only .0003" -.0004" backlash. Ideas on cost and procedure?    |
|
#2
10-21-2008, 08:59 PM
| |||
| |||
I think I recall the way set from Fadal is around 1800 bucks. I believe you may be able to buy from FadalCNC ( I think that is the name) or one of the other Fadal part houses cheaper. I have a small rust spot on my 15XT that so far is not a problem, but may grow into one someday, so I'm interested in what you come up with. Steve Last edited by scadvice; 10-22-2008 at 03:50 PM. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Choise the right linear guide | Cardedon | DIY-CNC Router Table Machines | 3 | 03-31-2008 02:56 AM |
| Guide wire linear motion | AustinT | Linear and Rotary Motion | 10 | 08-14-2007 09:36 PM |
| Fuse And Linear Guide | Alex S.A | General Metal Working Machines | 0 | 03-18-2007 06:48 PM |
| Diameter of shaft for linear-guide | Phantom | DIY-CNC Router Table Machines | 7 | 10-26-2005 11:11 AM |
| Support for linear guide | wile_e | Mechanical Calculations/Engineering Design | 7 | 01-29-2005 06:30 PM |
| | |
I have no help other than... 
Linear Mode
