help me gibbscam screw up - CNCzone.com-The Largest Machinist Community on the net!

bigjohn070 · #1 10-12-2004, 11:36 PM

Hello everyone. i have always used mastercam until i switched jobs. know need to learn gibbs. have been manual programming so far but to make things worse i left a disc in the drive when i turned off the fadal and windows will not boot up any more this must be a common problem with every one it was so easy to do thank you in advance BIG JOHN

Neal · #2 10-13-2004, 01:10 PM

BJ--
If you still have the disk in A drive, remove it. The bootup sequence is set to look at the A drive first for the operating system then look to C drive if it doesn't find it.
Leaving a disk in the drive during power down should not have cause any problems for boot up. (Unless you leave the disk in the A drive during boot up).

Neal

bigjohn070 · #3 10-15-2004, 09:39 PM

not for sure what happened. when you turn the switch from cnc to pc it says something about a boot disc for windows. i will be more specific on my next post thank you BIG JOHN

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Lead screw whip	spalm	DIY-CNC Router Table Machines	3	05-24-2005 03:04 PM
Ball Screw Identification	BeerFizz	Benchtop Machines	2	04-07-2005 11:28 AM
How to machine a 56 Rockwell lead screw	bgolash	General Metalwork Discussion	6	12-05-2004 04:25 AM
Ball Screw or Lead Screw? Which is Better?	ljoe1969	DIY-CNC Router Table Machines	4	07-28-2004 09:49 AM
Build a CNC Router - FAQ	samualt	DIY-CNC Router Table Machines	7	04-13-2004 09:55 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)