Need Help! programing a dwell cycle - CNCzone.com-The Largest Machinist Community on the net!

pacnc · #1 08-27-2008, 09:45 PM

Hi,I run a mazak v-5 with a fanuc system6 control.It is g-code.It has been a long time since I programed and I forget how to program a dwell.can you give me a example part program?if it helps I'm using a 1" E.M. going .375" dp and just need a cycle to break the chips at the bottom of the counterbore.thank you for your help!

dpark1 · #2 08-28-2008, 11:01 PM

If you are using a drilling cycle you can just add a P1500 for a 1.5 second dwell to your drill line.Also use G4 for dwell while milling.

milldoe · #3 08-29-2008, 11:26 AM

use a G82 for your drill cycle with a P for your dwell

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dwell Question	mkaake	G-Code Programing	16	11-03-2010 10:49 PM
PRGRAM DWELL	BAD DOG	Daewoo/Doosan	3	03-21-2008 12:04 AM
DWELL	BAD DOG	G-Code Programing	5	03-20-2008 02:29 PM
changing dwell in peck cycle	cncmedcom	Post Processor Files	0	02-03-2007 02:31 AM
Q: How to dwell	Teps71	Milltronics	18	04-07-2006 04:32 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)