Build Thread how centering new axis - CNCzone.com-The Largest Machinist Community on the net!

Masi · #1 05-25-2008, 01:21 PM

I will get new x-ballscrew. Old get broken, and fadal 15xt was turn off immediately. How I centering axmotor/ screw for cold start position? Put power on and do cs command, axle motor away from axle, and turn table by hand on to the center mark, and assembly motor on place?
Is that correct way to do it?

Neal · #2 05-27-2008, 09:46 AM

The Fadal uses software travel limits. The index mark is on the Resolver/Encoder. The method of setting the cold start position depends if this machine has AC or DC servo motors.

Neal

Masi · #3 05-28-2008, 03:53 PM

ooke. motor is glentek inc model gm405uf-ic mtr 0002 ? that all I can see. fadal is -95 year..

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
A BETTER TAP WRENCH! SELF CENTERING!	northernmach	Product Announcements & Manufacturer News	19	08-28-2010 02:13 PM
USB Webcams for Centering	towertek	General Electronics Discussion	2	06-01-2008 09:16 PM
Need Help!- Need help with Set-Tru chuck centering	dpseafish	General Metalwork Discussion	10	03-16-2008 08:14 PM
centering problem	settingbur	CNC Swiss Screw Machines	2	03-07-2008 07:47 AM
Centering a 4-Jaw chuck	gdl357	Mini Lathe	10	09-20-2004 06:24 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)