Work NC post for Fadal

[Savageson]

Would anyone be able to share a post config file that will work on a Fadal control. I have edited one to use but I cant figure out how to get the feed comands to post in the correct format. (F100 need F100.) Thank you for any information.

[dcalp]

if one for FeatureCam would work i could probably do it.

[Copell]

What software are you looking to post from. I have a Mastercam post and a Gibbscam post that I know work.

[Edster]

He said he needed a post for work nc. I don't think any other cam software post will work with work nc, there not interchangable.

[Dan B]

If you send your post to cncdanb@gmail.com I will configure it for you and send it back.

Dan (WorkNC user since 1994)

[KRANKSTUH]

how would i go about getting a post for a fadal vmc 4020 88 hs

[Dan B]

Contact your WorkNC reseller. They should be able to help you. You do have maintenance, right?

[Shawn Schwartz]

Savageson, if you contact our office, as long as you are on maintenance, someone would be more than happy to help you. I work for the company and handle Iowa, Wisconsin, Illinois, Minnesota and most of Michigan. If any of you have any questions about WorkNC, I would be happy to answer them.