Problem Inhibit spindle alarm - CNCzone.com-The Largest Machinist Community on the net!

bigbobr · #1 02-15-2008, 10:06 AM

I have been programing, running a 16x22 Fadal vmc, with Fanuc 01,mc controls for about a year. So far not too many problems. Today I am throwing up an Alarm 1105 message- Inhibit spindle CMM, ATC not A... This is happening after a tool change, with various tools. Anyone have any clue to this?? Thanks

Neal · #2 02-15-2008, 11:38 AM

Look at sensor 805DV1. Look at the signal status screen at X7 bit 0. It runs thru board C002 at XT70A-19.
That sensor may not be reading correctly or the ATC is not physically all the way home.

Neal

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Inhibit vs phase chopping	stragenmitsuko	Open Source Controller Boards	0	02-02-2008 11:18 AM
Need Help!- spindle alarm	bhupinder	Fanuc	1	01-31-2008 01:24 PM
Spindle Alarm	phoodieman	Daewoo/Doosan	2	03-16-2007 07:06 PM
alarm! spindle overcurrent	jianjianca	Bridgeport and Hardinge Mills	2	04-26-2006 10:35 PM
Quesion regarding inhibit jumper settings for Fanuc drive	cncboy	CamSoft Products	1	03-07-2005 05:43 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)