Carousel Problems - CNCzone.com-The Largest Machinist Community on the net!

gamila · #1 11-06-2007, 07:26 AM

Hello All,

I have a 1993 Fadal VMC20. The tool carousel will not rotate CCW either manually or by command. This problem just started yesterday, have had no problem with this before. I would really appreciate any help.

Thanks,
gamila

Neal · #2 11-06-2007, 09:17 AM

Check relays K11, K5 and fuse F5 these are the controls for the turret reverse.

Neal

gamila · #3 11-06-2007, 10:52 AM

Neal,

I swapped K11 and K12 relay boards and it is working fine. There must have been crud or something on them.
Thank you!!

gamila

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
VF-2SS Tool Carousel Problem	JoBwan	Haas Mills	18	05-25-2011 01:07 PM
tool carousel position problem	Greg 24	Haas Mills	4	10-19-2009 03:44 PM
tool carousel alignment	rubino2112	Machine Problems, Solutions , Wireless DNC, serial port	0	12-27-2006 12:26 PM
Spindle Bearing/Tool Carousel Motor???	AdvancedMfg	Industrial Hobbies (Support forum)	0	12-04-2005 09:25 PM
carousel, turret or magazine	mjiba	General Metal Working Machines	2	10-14-2004 05:07 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)